Single arm pneumatic drop test machine
- Option1: Clip-on fixture designed specifically for hand-held device testing.
- Option2: digital control box, automatic lift control, can solve the problem of error resulted from observation of indicator more than 160cm test.
- The swing arm system is controlled by the air pressure for fast and precise positioning. Maximum load: 65Kg, test height 30 – 160cm, swing arm platformsize 29x50cm, power requirements 220V 50 / 60Hz single-phase, air pressure requires more than 5kg / cm2.
- Lifting method: using motor drive, height can be adjusted.
- Test angle: angle, line and face of packaging container.
- Micro-switch: upper and lower limits with micro-switch to prevent accidental operation of the impact, to protect the machine.
- Tape measure: with 160cm long roll tape, and the indicator that can quickly see the actual scale movements.
- Fall plates: the use of aluminum alloy material which does not rust, and falling noise is small.
- Control button: The use of the button magnetic switch, only a light press on the DROP button, the plates can automatically fall, and can be adjusted up and down.
- Leadscrew pole: the level of fall with round lead screw pole, can lift up and down vertically and smoothly.
- Control box: The machine and the control box are separated and can be controlled in a safer way to prevent the operator from injury due to falling.
- Grinding rod: The spindle withone ψ150 mm, which uses the grinding spindle, to prevent swinging from side to side.
- Horizontal angle: There are four horizontal adjustable angles, with adjustable base level.
Cushion packaging design, packaging material selection, packaging contend design, drop specifications test.