Notice: Undefined offset: 1 in /home/jackycho/public_html/ on line 1015

Handle’s Vertical Tube Vibration Fatigue Tester ( One Is Up And The Other Is Down )
Use this machine exclusively to test bike’s handle by setting the specimen on test bench, then, exert the test-standard-specified load and speed on both sides to make test runs up to the set times and tester is shutdown automatically. Check the specimen’s status under test. This tester is produced according to the design standards defined in ISO 4210 and DIN 79100.

Modle HT9711-5
(Bench Top Type)
(Floor Standing Type)
HT9711-10 HT9711-25
Power source Electro-Hydraulic Servo Control System
Electro-Hydraulic kg 500 1000 2500
kn 5 10 25
Max. Stroke (mm) (Static) ±50
(Dynamic) ±25
Control mode (force, displacement control)
Static force sensor capacity x120%, x100%, x50%, x20%, x10% (Auto Gain selection)
Static force sensing error <=±1% (Auto Gain selection)
Dynamic force sensor capacity 100%, x50%, x20%, x10%
Dynamic force sensing error <=±1% (Calibration error)
Style T type
Operating width (mm) 400
Operating height (mm) 250~900
Dimensions (WxDxH) (cm) 120 x 65 x 220
Hydraulic power QR-10 QR-20 QR-40 QR-60 QR-80 QR-10
Minimum flow rate (l/min) 10 10 40 60 80 10
Servovalve rated flowrate (l/min) 15 15 45 80 120 15
Displacement sensor 1 L (Option) 5L (Option) 1 L (Option)
Frequency range (LVDT built-in actuator);0.05~50Hz
dimension, table, stroke, and capacity can be made to order depending on customer requirements
© Copyright - Hungtatester