INDENTORS FOR ALL HARDNESS SCALES™

With official calibration certificates UKAS, DKD or ASTM

CV Instruments offers a wide range of indentors. All certified indentors will be issued with a certificate traceable to internationally recognised standards such as UKAS, DKD or ASTM. We also offer low cost factory certified indentors and specials (see below). Specials CV Instruments also offer special adapters for indentors to enlarge the field of application. Small gooseneck adaptors are available in three sizes to permit regular or superficial Rockwell hardness testers to perform internal tests on rings, tubes and annular parts where the inside diameter, plus the wall thickness, is less than 50.8mm or 2 inches. These adaptors will fit any of the standard Rockwell hardness testers. The gooseneck adaptor can be clamped into the bottom of the plunger rod (in the same manner as an indentor) and is not heavy enough to affect a reading due to increasing the applied load. The minimum internal diameter which can be tested is 11.5mm or 7/16 inch. Ask for our separate product list of indentors.

Identor type CV Instruments
Scale	UKAS	DKD	ASTM	CV
Rockwell type 120? diamond cone	x	x	x	x
Rockwell ball indentors	x	x	x	x
Steel Rockwell ball indentor - 1/16? dia.
Steel Rockwell ball indentor - 1/8? dia
Steel Rockwell ball indentor - 1/4? dia.
Steel Rockwell ball indentor - 1/2? dia.
Carbide Rockwell ball indentor - 1/16? dia.
Carbide Rockwell ball indentor - 1/8? dia
Carbide Rockwell ball indentor - 1/4? dia.
Carbide Rockwell ball indentor - 1/2? dia.
Spare steel balls Rockwell in packs of 10	x	x	x	x
Spare carbide balls Rockwell (singles)	x	x	x	x
Brinnell ball indentors	x	x	x	x
Carbide ball indentor - 1mm dia
Carbide ball indentor - 2mm dia
Carbide ball indentor - 2.5mm dia
Carbide ball indentor - 5mm dia
Carbide ball indentor - 10mm dia
Spare Brinell carbide balls (singles) all sizes	x	x	x	x
Vickers Pyramid 136°	x	x	x	x
Micro Vickers 136°	x	x	x	x
Micro Knoop	x	x	x	x